TP8 Probe

Renishaw TP8

The TP8 probe offers an entry level option for customers that require infrequent indexing of the probe and no indexing during the running of a measurement program. The TP8 is supplied with two knuckle joints to allow infinite alignment of the probe to the feature being measured, but this alignment is non repeatable, meaning that the stylus will need to be requalified following each index. The TP8 probe accepts the M3 range of styli.

MH20i Probe Head

Renishaw MH20i

The MH20i probe offers repeatable manual indexing of the probe head from 0° to 90° in the A axis and through 360° in the B axis, in 15° increments. Ideal for manual CMMs, it can also be used on DCC models, but will require intervention from the operator whenever indexing is required. The MH20i uses a TP20 stylus module, which in turn accepts the M2 range of styli.

RTP20 Probe Head

Renishaw RTP20

The RTP20 probe offers a cost effective solution for customers that require automatic indexing on DCC machines. Modeled on the MH20i body, the RTP20 uses the DCC motion of the CMM to position itself using a post mounted to the bed of the machine. Like the MH20i it is able to index from 0° to 90° in the A axis and through 360° in the B axis, in 15° increments and uses a TP20 stylus module, which in turn accepts the M2 range of styli. The RTP20 is also fully compatible with the MCR20 change rack to provide an option that provides both automatic stylus changing as well as automatic indexing.

PH10T Probe Head

Renishaw PH10T

The PH10T is a fully motorized probe head that offers immediate indexing from 0° to 105° in the A axis and through 360° in the B axis, in 7.5° increments. This probe head should be used by customers requiring frequent indexing or when more precise alignment to the features being measured is required.

PH10M Probe Head

Renishaw PH10M

The PH10M is a fully motorized probe head that offers immediate indexing from 0° to 105° in the A axis and through 360° in the B axis, in 7.5° increments. The PH10M incorporates a multiwire autojoint, enabling the use of the SP25M scanning probe, as well as TP20 and TP200 touch probes and is the best head to install if scanning is required now, or in the future.

PH6M Probe Head

Renishaw PH6M

This head provides a fixed autojoint for when an SP25M scanning probe is required without the requirement for indexing.

SP25M Scanning Probe

The SP25M scanning probe uses an isolated optical metrology transducer system to enable extremely accurate measurements to be taken with the stylus in continuous contact with the feature being inspected. This enables more data to be taken, which is important when form is critical. A range of modules are available for the SP25M to provide optimized scanning performance using M3 styli up to 15.7" long.

PH20 Probe Head

Renishaw PH20

Incorporating the latest 5-axis technology, the PH20 head offers infinite indexing to assist with alignment to any feature being measured at any angle up to 120°. The probe is able to perform 'head touches', where it flicks the stylus on to the surface of the component being measured, while the machine remains stationary. This increases both the speed of measuring and accuracy achievable. Please note that if selecting the PH20 head, then the machine would also have to be fitted with a Renishaw CMM controller. The PH20 uses TP20 stylus modules, which in turn accept the M2 range of styli.